2. A clean shaved face with mustaches no wider than mouth.
Class ARank: 1/2 inch from the edge of the shoulder seam. Arrows always point towards collar.
School Shoulder Patch: Centered on shoulder sleeve. 1/2 inch down from the shoulder seam.
JROTC Shoulder Patch: Centered on shoulder sleeve. 1/2 inch down from the shoulder seam.
Star: 1/4 inch above the top of the pocket. Centered (left-right) with the pocket.
Academic Wreath: 1/8 inch above the top of the pocket. Centered (left-right) with pocket. Star is placed inside the wreath.
Name Tag: Centered between the top of the pocket and the pocket button.
School Crest: Centered (left-right) on pocket and centered between the bottom of the pocket flap and the bottom of the pocket.
Ribbons: Center on the pocket. Stacked from the top of the pocket.
Pins: Centered (top-bottom) between the bottom of the flap and the bottom of the pocket. Each pin is placed 1/4 inch apart from each other.
Cords: A maximum of two cords can be worn. If one is worn, it goes on the left. If two are worn, the highest goes on the left.
Class BBoard Rank: On shoulder tabs.
Name Tags: Centered between the top of the pocket and the pocket button.
Ribbons: Centered on the pocket and stacked up from the top of the pocket.
Star: 1/4 inch above the top of the pocket and centered (left-right) with the pocket.
Wreath: 1/8 inch above the top of the pocket and centered (left-right) with the pocket. The star is worn inside the wreath.
School Crest: Centered (left-right) with the pocket and centered between the bottom of the pocket flap and the bottom of the pocket.
Pins: Centered between the bottom of the pocket flap and the bottom of the pocket. Each pin should be 1/4 inch apart from each other.
Cords: A maximum of two cords can be worn. If one is worn, it goes on the left. If two are worn, the highest goes on the left.
BDUEnlistedName Tag: Placed 1/4 inch above the seam of the pocket and centered (left-right).
JROTC Patch: Placed 1/4 inch above the seam of the pocket and centered (left-right).
OfficerName Tag: Placed 1/4 inch above the seam of the pocket and centered (left-right).
JROTC Patch: Placed 1/4 inch above the seam of the pocket and centered (left-right).
Rank: Placed one inch in from the top edge of the lapel on the jacket. Rank is placed straight up and down.
JROTC Pin: Placed one inch on from the top edge of the lapel on the jacket. Rack is placed straight up and down so that the "R" is on the bottom.
How To Tie a TieThe Windsor Half-Knot
1. Start with the wide end of the tie on your right. Extend it about 12 inches below the narrow end.
2. Cross the wide end over the narrow, and turn back underneath.
3. Bring the wide end up, and turn down through loop.
4. Pass the wide end around to the front from your left to right.
5. Bring the wide end up through the loop.
6. Pull the wide end through the knot in front. Tighten and draw up to collar.
The Windsor Knot
1. Start with the wide end of the tie on your right. Extend it about 12 inches below the narrow end.
2. Cross the wide end over the narrow, and bring it up through the loop.
3. Bring the wide end down, around behind the narrow, and up on your right.
4. Put this end down through the loop and across the narrow (as shown).
5. Turn the wide end, and pass it through the loop.
6. Complete the knot by slipping the wide end through the knot in front. Tighten and draw up to collar.
The Four-in-Hand Knot
1. Start with the wide end of the tie on your right. Extend it about 12 inches below the narrow end.
2. Cross the wide end over the narrow, and back underneath.
3. Continue by bringing the wide end around, passing it across the front of the narrow once more.
4. Pass the wide end up through the loop.
5. Holding the front of the knot loosely with index finger, pass the wide end down through the loop in front.
6. Remove finger, and tighten knot. Carefully, draw up tight to collar, holding the narrow end and sliding the knot up snug.